No LED’s Are Lighting


  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #1353
    gofaster
    Member

    I have a Dyno Max Pro, 10.23 SP#1
    None of the LED’s are lighting on the DYNOmite Data Computer and Controller.
    The power source shows 12v DC, ground on the body, power at the tip.
    I tried cycling the power with a jumper on pins 5 & 6 on the weather station plug and still nothing.
    Is there any other kind of reset that I can do or is this a board problem?

    Yesterday I was getting a red LED that lit after I put a new RS232 adaptor on the cable that goes to my laptop.
    Today I have nothing.

    #5189
    kevin
    Member

    If you have no Green light it indicates no power is reaching the board. Open the back of the data computer (4) screws and be sure the power tip is is firm in the receptical.

    #5193
    gofaster
    Member

    Thank-you Kevin. That’s all it was.

    LED’s are working and the laptop appears to be communicating.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.