power and torque measurement problem


  • This topic is empty.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #1336

    Hi Dyno people, I have one question, I have a dyno with 44″ roll, and water brake, I have this problem :
    I test a Honda K20z3 the car test in my dyno and I have 225 Hp, I change a engine for K20A Type R, the power and torque curves are the same, I improve the two lines and the graphics are identicals, I test the car in the truck but with K20A the car is to fast about 10 km/h in end speed and 2 seconds for lap, the question is why if the two lines for two engines are identicals , the car is more fast?
    I test a power only with inertial mode,
    please help me.

    #5161
    ryan
    Member

    Alvaro – Can you email me the DYNO-MAX files for an evaluation (ryan@land-and-sea.com)? I should be able to figure out any major differences fairly quickly.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.