WEGGO IIID sensors data not showing in Windows 10 upgrade


  • This topic is empty.
Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #1358

    Recently upgraded my engine dyno to Windows 10 computer and had to reload my Pro software from 2010. Everything seems to work fine exepct the WEGGO IIID wide band A/F sensors’ data is not showing on console. I can see a Raw signal voltage in the “Calibrate” channels tab, so I know the data logger is reading the wide band sensors. It just doesn’t show on the console. I copied over all of the gauge settings from my old WIN7 system, so all is the same. Land & Sea have not been able to help so I’m reaching out to you guys. Thanks.

    #5201
    adam
    Member

    Share a run file and I’ll take a look.

    #5202

    Adam, I tried to attach a ZIPPED run file, but says it’s too large. Won’t upload. Do you know another way?

    #5203
    adam
    Member

    You can use google drive, onedrive, dropbox etc to share the file.

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.